Pay in 4 interest-free payments of $9.88 Learn more
Ships within 48 hours · Estimated delivery Aug 13 - Aug 18
Roof Guard Rails
Plantation grown Radiata Pine that has been finger jointed and laminted for stability
The 251 Slope Base Flange (30 degree to 45 degree) is a base flange for sloping sites
The 153 Short Slope Tee D48 is a butt joint for sloping sites
The 140 Gate Hinge Pin is often used with type 138 to form gate hinges
Sloping Elbow (0-11 degrees) for 34mm Galvanised Pipe Slim Tapered Leg Roof Guard RailsWhere would you normally use this galvanised pipe fitting? The 154 Slope Elbow is an angle joint adjustable for slopes from 0 degree to 11 degree, normally used where top rail meets end upright on sloping sites. What size pipe does it fit to? This fitting will work with galvanised pipe (tube) of an outside diameter of approximately 34mm. What is it made out of? All of the pipe fittings are made from malleable iron and then hot dipped galvanised to
US$ 59.00
US$ 12.00
US$ 39.00
US$ 29.00
US$ 69.00
US$ 99.00
US$ 79.00
US$ 69.00
US$ 12.00
US$ 74.00
US$ 28.00
US$ 14.00
US$ 10.00
US$ 28.00
US$ 19.00
