Designer Rail Alignment Jig for Stainless Fittings Corbel often used where top rail

often used where top rail meets corner upright on level sites

hinges etc

Overall : 1090mm Height x 16mm Width x 16mm Depth

it can be trimmed back to 37 degree to form part of the handrail on a staircase when needing to change from the horizontal plane to a 37 degree incline (most stairs are pitched at 37 degrees)

Overall : 19mm Diameter x Various Lengths

Designer Rail Alignment Jig for Stainless Fittings Corbel often used where top railWhere would you normally use it? To centrally fit the DESIGNER RAIL connector (IF131XS4) to the end of the straight rail when a stainless bend or end cap needs to be added. This jig is ONLY suitable for use with the stainless fittings. If you need to fix the timber bends or end caps, then you need to use the IF121X 43. What do I get? A precision machined stainless sleeve suitable for 43mmm DESIGNER RAIL.